Author Topic: How detectors are made, short video.  (Read 3125 times)

0 Members and 1 Guest are viewing this topic.

Keith67

  • Hero Member
  • *****
  • Posts: 6397
  • XP Deus, GM1+UK
How detectors are made, short video.
« on: September 24, 2017, 08:15 pm »
Nothing ground breaking about this but some may find this short video interesting.

https://www.youtube.com/watch?v=bxxuSY6j110

Flirt with the dirt, beep, dig, dance....

JBM

  • Gold Membership
  • *
  • Posts: 3254
Re: How detectors are made, short video.
« Reply #1 on: September 25, 2017, 08:39 am »
Good post Keith.
Happy Hunting,
Jerry.

Fez

  • Gold members
  • *
  • Posts: 149
Re: How detectors are made, short video.
« Reply #2 on: September 25, 2017, 03:45 pm »
Thanks Kieth interesting I know why I don't find stuff they've forgot to put a circuit board In mine  ;)

Keith67

  • Hero Member
  • *****
  • Posts: 6397
  • XP Deus, GM1+UK
Re: How detectors are made, short video.
« Reply #3 on: September 25, 2017, 08:20 pm »
Thanks Kieth interesting I know why I don't find stuff they've forgot to put a circuit board In mine  ;)

That made me chuckle Fez  ;D
Flirt with the dirt, beep, dig, dance....

AmazingLeopard

  • Guest
Re: How detectors are made, short video.
« Reply #4 on: October 06, 2017, 08:54 am »
Nice share of video Metal detectors are primarily made up of the battery case, and electronic box on one end. The long handle or brace is the operator’s arm which you use to search and detect metal targets underground. The insulated wire then extends from the box, then wraps into the shaft, which connects to the round disk which is the coil. This disk is actually covered by

a shield (sometimes plastic made) which is then attached to the handle’s shaft at a certain angle. This position allows you to hold the search device parallel to the surface.

GP27

  • Guest
Re: How detectors are made, short video.
« Reply #5 on: October 06, 2017, 05:58 pm »
Interesting video, thanks for that share.