Gary's Metal Detecting Forum

Gary's Detecting forum => General detecting talk => Topic started by: Keith67 on September 24, 2017, 08:15 pm

Title: How detectors are made, short video.
Post by: Keith67 on September 24, 2017, 08:15 pm

Nothing ground breaking about this but some may find this short video interesting.

https://www.youtube.com/watch?v=bxxuSY6j110

Title: Re: How detectors are made, short video.
Post by: JBM on September 25, 2017, 08:39 am

Good post Keith.
Happy Hunting,
Jerry.

Title: Re: How detectors are made, short video.
Post by: Fez on September 25, 2017, 03:45 pm

Thanks Kieth interesting I know why I don't find stuff they've forgot to put a circuit board In mine  ;)

Title: Re: How detectors are made, short video.
Post by: Keith67 on September 25, 2017, 08:20 pm

Quote from: Fez on September 25, 2017, 03:45 pm

Thanks Kieth interesting I know why I don't find stuff they've forgot to put a circuit board In mine  ;)

That made me chuckle Fez  ;D

Title: Re: How detectors are made, short video.
Post by: AmazingLeopard on October 06, 2017, 08:54 am

Nice share of video Metal detectors (https://www.bestmetaldetectorreview.com/) are primarily made up of the battery case, and electronic box on one end. The long handle or brace is the operator’s arm which you use to search and detect metal targets underground. The insulated wire then extends from the box, then wraps into the shaft, which connects to the round disk which is the coil. This disk is actually covered by

a shield (sometimes plastic made) which is then attached to the handle’s shaft at a certain angle. This position allows you to hold the search device parallel to the surface.

Title: Re: How detectors are made, short video.
Post by: GP27 on October 06, 2017, 05:58 pm

Interesting video, thanks for that share.